M100 FILTERS

M100 FILTERS

General


The  M100 Series are ideal for remote installation sites, with a water-driven self-cleaning mechanism that doesn't require external power source to operate. With their various screen areas the M100 models support flow-rates of up to 400 m³/h (1760 US gpm), with filtration degrees of 500 down to 80 micron and inlet/outlet diameters from 2"-10".

Features:


- Large filtration area, reliable operating mechanism and simple construction make the M100 filters the ideal solution for agricultural and municipal filtration systems where no power is available

- Automatic flushing according to pressure differential

- No interruption of downstream flow during flushing

- Minimal volume of reject water


How the FILTOMAT M100 Filters Work

 

The Filtering Process


The filtration process begins when raw water flows through the filter inlet (1) into the coarse screen (2). Here, the water is pre-filtered in order to protect the cleaning mechanism from large debris. The water then passes through the inner surface of the fine screen; dirt particles are trapped and accumulate inside the filter while clean water flows through the filter outlet. The gradual dirt buildup on the inner screen surface causes a filter cake to develop, with a corresponding increase in the pressure differential across the screen.

 

The Self-Cleaning Process


When the pressure differential across the screen reaches a pre-set level of 0.5 bar, the M100 filter's rinse controller (3) starts the cleaning process by opening the internal flush valve (4). This results in the release of a back-flush stream, flowing through the nozzles (5) out of the hollow Suction Scanner Shaft (6) and the Turbine (7) to the Drainage pipe (8).

 

M100 Models


FILTOMAT M100 Series consists of the following models:


- M100-750 for up to 40 m³/h (176 US gpm)

- M100-1500 for up to 80 m³/h (352 US gpm)

- M100-4500 for up to 180 m³/h (793 US gpm)

- M100-6800 for up to 400 m³/h (1760 US gpm)

 

barbour jackets
Michael Kors Outlet